Advertisement
3
HOOD SAFETY SWITCH MOUNTING, continued
3. Remove (2) push pins from driver's side of hood insulation (FIGURE M). Tuck the wiring from the
hood safety switch under the hood insulation and route towards the driver's side of the hood.
(FIGURE N)
FIGURE M
4. Using one of the supplied tie wraps, secure the wiring to the engine side of hood bracket. (FIGURE
O) Remove screw and plastic screw retainer assembly from bottom edge of cowl trim panel (be
careful not to loose plastic screw or retainer clip). (FIGURE O) Route hood safety switch wire
under plastic cowl trim panel as shown. (FIGURE O) Replace previously removed screw plastic
retainer assembly. Route hood switch safety wire behind MAP sensor. (FIGURE P) Reinstall screw
and plastic screw retainer assembly in bottom edge of cowl trim panel, insure that plastic retainer
assembly is fully seated.
FIGURE O
5. Carefully pierce hole in the top of main bulkhead harness grommet from engine compartment into
the passenger compartment. Place wire-fish through hole from passenger compartment out into
engine compartment. (FIGURE Q) Tape hood safety switch to wire-fish and gently pull wire through
hole in bulkhead grommet and release wire from wire-fish. Seal hole with silicone and re-install
the vehicle's battery.
FIGURE Q
FIGURE N
FIGURE P
Caution: Do not attempt to pierce or route wire
through center section of grommet with OEM wires
which are protected with dielectric grease.
4
1030832 Rev.A 10/05
Advertisement
