Returning The Dvd Player To The Works Settings; Switching Off The Dvd Player; Cleaning The Dvd Player - Silvercrest KH 6508 Operating Instructions Manual

• ... on some DVDs/VCDs/S-VCDs with a printed par-
ent guidance rating, the child lock will not indicate
any function in connection with the set age release
rating.
Please note:
Should you have forgotten your password, then you
can continue with the works set "8888" password.
Returning the DVD Player to the works
settings
If you wish to reverse all the settings you have made in the
OSD menu back to the original works settings, then proceed
in the following manner ...
1 In the event that a disc loaded in the DVD Player is cur-
rently being played, then terminate this by pressing the
"Stop" button on the front of the DVD Player, or on the
remote control, once.
2 Press the "Setup" button on the remote control to display
the OSD menu on the television screen.
3 Press the control button
item, and then press the "OK" button on the remote con-
trol.
4 The "Parental" menu is then displayed with its sub-items ...
Password – – – –
Rating G
Load factory Reset
The "Password" menu sub-item is the fi rst to be automati-
cally selected.
5 Press the control button
menu sub-item. The "Reset" option is then marked.
6 Press the "OK" button once.
7 The DVD Player is then returned to the works settings.
Wait for ten seconds before restarting the DVD Player.
Please note:
Please realise that returning to the works settings will
cancel all your previous settings in the OSD menu!
Warning:
A return to the works settings will also change the
Stereo Downmix settings. In the event that ...
to select the "Parental" menu
to select the "Load Factory"
• The DVD Player is connected to a stereo televi-
sion and no audio units are connected to the DVD
Player, or
• A Dolby Prologic-compatible audio unit has been
connected to the stereo output (via a chinch cable
and the chinch sockets "FL" and "FR") of the DVD
Player – as described in chapter "Connecting a HiFi
system"
... then there will be no sound, or only very soft, dur-
ing playback of DVDs, VCDs/SVCDs and audio-CDs,
MP3 or WMA CDs, after returning to the works set-
tings. In this case the previous speaker settings for
Stereo Downmix in the OSD menu, "Audio" menu item,
"Size" sub-item, must be returned to the previous
settings:
• Front: LARGE
• Center: Off
• Rear: Off
• Subwoofer: Off
➧
For this subject please refer to chapter 9.4, "Audio Set-
tings: Setting Speaker Sizes – Stereo Downmix"
Switching off the DVD Player
Proceed in the following manner to switch off the DVD
Player ...
1 In the event that a disc loaded in the DVD Player is be-
ing played, then terminate this by pressing the "Stop"
button on the front of the DVD Player, or on the remote
control, twice.
2 Open the disc drawer so that a disc loaded in the DVD
Player can be removed when the "Open/Close"
on the front of the DVD Player, or on the remote control,
is pressed once. Reclose the the disc drawer by pressing
the "Open/Close" button once.
3 Press the "Standby" button on the remote control once.
The DVD Player will then be switched over to operating
readiness or to "Standby mode". Press the "Standby" but-
ton to switch on the DVD Player.
To switch off the DVD Player entirely press the "Power"
button on the front of the DVD Player once.

Cleaning the DVD Player

Only use a slightly moist cloth with a mild detergent to clean
the case surface of the DVD Player. Ensure that no moisture
can enter the DVD Player when it is being cleaned!
Clean the inside of the disc drawer – if necessary – only
with a clean, dry brush (e.g. lens brush available from pho-
button
Silvercrest KH 6508/KH 6509 