Programmed Playback (Program) - Silvercrest KH 6508 Operating Instructions Manual

tain titles on the CD-R/CD-RW with MP3 or WMA fi les
for playback. You can decide the sequence in which the
titles are played.
If there are folders: With this function you can compile
your own music programme by selecting certain titles
within the current sub-folder for playback. You can decide
the sequence in which the titles are played.
➧
To operate the "Programmed Playback" function please
refer to Chapter "Programmed Playback (Program)".
Single Track
If there are no folders: The currently selected title is
played once again.
If there are folders: The currently selected title in the
current sub-folder is played once.
Repeat Single
If there are no folders: Playback of the currently selected
title is repeated.
If there are folders: Playback of the currently selected ti-
tle in the current sub-folder is continuously repeated until
termination by pressing the "Stop" button twice.
To select the Play Modes ....
1 In the event that a CD-R/CD-RW with MP3 or WMA fi les
is being played, then playback is terminated by pressing
the "Stop" button on the front of the DVD Player or on
the remote control once.
2 Press the control button
titles of a sub-folder (the mark is therefore in the right-
hand half of the CD-R menu; see fi g. 1). The mark will
then change to the mode select bar; the preset "Folder
Normal" mode has been selected (see fi g. 2).
CD-R MENU
ROOT
Folder 1
Folder 2
MP
Mode Folder Normal
Fig. 1
CD-R MENU
ROOT
Folder 1
MP
Folder 2
MP
Mode Folder Normal
Fig. 2
once whilst in the list of the
..
Volume 1 – Title 1 1
MP
Volume 2 – Title 2
..
Volume 1 – Title 1
Volume 2 – Title 2
3 One of the Play Modes is displayed with each depres-
sion of the "OK" button. When the required play mode
is displayed, then leave the mode select bar by pressing
the control button
located in the list of the titles of the previously selected
sub-folder.
4 Proceed as follows to playback titles in the set mode ...
If there are no folders:
• Press the "Play" button once to start playback of the
fi rst tile on the CD-R/CD-RW
• Press the "OK" button once to start playback at the cur-
rently selected title.
If there are folders:
• Press the "Play" button once to start playback of the
fi rst title in the current sub-folder
• Press the "OK" button once to start playback of the cur-
rently selected title in the current sub-folder.

Programmed playback (Program)

Set the "Program Begin" mode to select several titles for pro-
grammed playback:
1 The fi eld "Program __:__" is faded in above the CD-R menu.
Select the fi rst titles to be programmed with the control
buttons and on the remote control.
If there are folders: Titles can only be selected for pro-
grammed playback from the currently selected sub folder
of the CD-R/CD-RW. Titles from diff erent sub-folders can-
not be selected for programmed playback.
2 Confi rm the selected titles by pressing the "OK" button
on the remote control.
0
3 The selected title is displayed as the fi rst stored title for
programmed playback in the faded-in fi le above the CD-
2
R menu – e.g. "Program 1:05" if the fi fth title of the cur-
rently selected sub-folder was selected as the fi rst title
for programmed playback.
4 Repeat the steps 1 and 2 until all the required titles have
been selected for programmed playback.
0
1 5 Then press the control button
2 mode select bar.
6 Press the "OK" button once; the "Program End" mode is
displayed in the mode select bar.
once. The mark is then once again
or
or
once to change the
Silvercrest KH 6508/KH 6509 