Yamaha CLP- 585 Owner's Manual page 113

5.
Connect the pedal cord and power
cord.
5-1 5-1
5-4
For models that feature a voltage selector:
Set the voltage selector to an appropriate
voltage.
Voltage Selector
Before connecting the AC power cord, check the setting of the
voltage selector which is provided in some areas. To set the
selector for 110V, 127V, 220V or 240V main voltages, use a
"minus" screwdriver to rotate the selector dial so that the
correct voltage for your region appears next to the pointer on
the panel. The voltage selector is set at 240V when the unit is
initially shipped. After the proper voltage has been selected,
connect the AC power cord to the AC IN and an AC wall outlet.
A plug adaptor may be also provided in some areas to match the
pin configuration of the AC wall outlets in your area.
WARNING
An improper voltage setting can cause serious damage to the
instrument or result in improper operation.
5-1.
Insert the plug of the pedal cord into the
pedal connector.
5-2.
Attach the cord holders to the rear panel as
shown, then clip the cord into the holders.
5-3.
Use a vinyl tie to take up any slack in the
pedal cord.
5-3
5-2
5-4.
Insert the plug of the power cord into the
power connector.
Insert the pedal cord securely
until the metal part of the
cord plug disappears from
view. Otherwise, the pedal
may not function properly.
6.
Set the adjuster.
Rotate the adjuster until it comes in firm contact
with the floor surface.
7.
Attach the headphone hanger.
Use the two thin screws (4 × 10 mm) to attach the
hanger as shown in the illustration.
CLP-585/575/545/535/565GP Owner's Manual
Assembling the Clavinova
113