Yamaha CLP- 585 Owner's Manual page 92

System Menu
To call up the desired parameter:
Press the [MENU] button several times to select "System Menu," then use the [ ]/[ ]/[<]/[>] buttons to select the desired
parameter.
[>] [>]
[<] [<]
MIDI Initial Setup
Backup Backup Setting
Backup
Restore
Factory Set
Utility USB Format
USB Properties
USB Autoload
Speaker
Contrast
92
CLP-585/575/545/535/565GP Owner's Manual
[>]
[<]
(Executing Transmits the current panel settings such as Voice
display) selection to a connected MIDI device or computer.
Before you start recording your performance to a
• Cancel
connected MIDI device or computer, execute this
• Send
operation to record the current panel settings at the
beginning of your performance data. It causes that the
same panel settings are called up when the recorded
performance is played back.
Operation:
Move the highlight to "Execute," then press the [>]
button to transmit the panel settings as MIDI messages.
For instructions about these functions, refer to pages 94
– 95.
Cancel This lets you format or initialize the USB flash memory
connected to the USB [TO DEVICE] terminal.
NOTICE
Executing the Format operation will delete all data saved in
the USB flash memory. Save important data to a computer or
another storage device.
NOTE
When connecting the USB flash memory to the [USB TO
DEVICE] terminal, a message prompting you to execute the
Format operation may appear. If such a case occurs,
Execute
execute the Format operation.
Operation
Move the highlight to "Execute," then press the [>]
button to start the Format operation. After the Format is
completed, a message appears then the instrument
returns to the Utility display after a while.
NOTICE
Never turn off the power or disconnect the USB flash memory
while "Executing" is shown in the display.
– Shows the amount of free space and entire memory in
the USB flash memory connected to the USB [TO
DEVICE] terminal.
– When this is set to "on," the Song saved in the root
directory can be selected (shown on the display)
automatically as soon as the USB flash memory is
connected to the USB [TO DEVICE] terminal.
(Setting display) Lets you switch the speaker on/off.
• Normal (HeadphoneSW)
The speaker will sound only if headphones are not
connected.
• On
The speaker will always sound.
• Off
The speaker will not sound.
(Slider display) Adjusts the contrast of the display.
Description
Amount of entire
memory
Amount of free
space
Default setting Setting range
– –
– –
– –
– –
Off On, Off
Normal Normal, On, Off
(HeadphoneSW)
0 -5 – +5