Yamaha CLP- 585 Owner's Manual page 109

5.
Connect the speaker cord.
5-1.
Remove the twist tie attaching the speaker
cord.
5-2.
Insert the speaker cord plug into the
connector so that the tab extends toward
the front when viewed from the rear.
6.
Connect the pedal cord.
6-1
6-3
6-1.
Insert the pedal cord plug into the
[PEDAL] connector.
6-2.
Attach the cord holders to the instrument,
then clip the cord into the holders. At this
time, be careful that the pedal cord isn't
loose between the plug and cord holder.
6-3.
Use a twist tie to bundle the pedal cord.
Insert the pedal cord securely
until the metal part of the
cord plug disappears from
view. Otherwise, the pedal
may not function properly.
7.
Insert the plug of the power cord
into the power connector.
For models that feature a voltage selector:
Set the voltage selector to an appropriate
voltage.
Voltage Selector
6-2
Before connecting the AC power cord, check the setting of the
voltage selector which is provided in some areas. To set the
selector for 110V, 127V, 220V or 240V main voltages, use a
"minus" screwdriver to rotate the selector dial so that the
correct voltage for your region appears next to the pointer on
the panel. The voltage selector is set at 240V when the unit is
initially shipped. After the proper voltage has been selected,
connect the AC power cord to the AC IN and an AC wall outlet.
A plug adaptor may be also provided in some areas to match the
pin configuration of the AC wall outlets in your area.
WARNING
An improper voltage setting can cause serious damage to the
instrument or result in improper operation.
Assembling the Clavinova
CLP-585/575/545/535/565GP Owner's Manual
109