Table of Contents
Advertisement
1.
Connect an Ethernet cable from the Pocket VoIP Gateway's LAN port to your
PC.
2.
Power on the Pocket VoIP Gateway by connecting the power adapter to a
nearby power source.
3.
Use your PC's web browser to access the Pocket VoIP Gateway's
management interface and run the Setup Wizard to scan the area and select a
specific access point for connection (refer to the Management Guide for
details). The Pocket VoIP Gateway has a default IP address of 192.168.7.1 and
a subnet mask of 255.255.255.0.
Note:
If your PC has an IP address assigned by DHCP (Dynamic Host Configuration
Protocol) or is set on the same subnet as the Pocket VoIP Gateway (that is, the
PC's IP address starts 192.168.7.x), you can connect immediately to the web
management interface. Otherwise, you must first change your PC's IP address to
be on the same subnet as the Pocket VoIP Gateway.
Wireless Access Point
Used as a wireless access point, the Pocket VoIP Gateway connects to an Ethernet
LAN switch and extends the local network to associated wireless clients (PCs or
notebooks with 802.11b/g wireless capability). From any nearby location, you can
then make a wireless connection to the Pocket VoIP Gateway and access the
Ethernet network resources, including local servers and the Internet.
In Access Point mode the Pocket VoIP Gateway supports no gateway functions on
its WAN port. Either the LAN port or the WAN port can be connected to a local
Ethernet LAN.
Note:
Access Point mode must be manually set using the web management interface.
For more information, refer to the Management guide.
Wireless Access Point
2-3
Advertisement
Table of Contents
