Table of Contents
Advertisement
Connecting the Pocket VoIP Gateway
To connect the Pocket VoIP Gateway to use its telephony functions, first connect
and configure the Pocket VoIP Gateway in the operating mode you want to use (see
the appropriate section in this chapter.), then follow these steps:
1.
Connect an RJ-11 telephone cable from the Pocket VoIP Gateway's PHONE
port to your standard (analog) telephone set.
2.
Connect an RJ-11 telephone cable from the Pocket VoIP Gateway's LINE port
to an available PSTN telephone jack.
3.
Use your PC's web browser to access the Pocket VoIP Gateway's
management interface and configure your VoIP and SIP settings (refer to the
Management Guide for details).
Note:
To make a PSTN call through the Pocket VoIP Gateway, you must first dial "*0"
on the standard telephone set. The default on the PHONE port is for VoIP calls.
2-6
Advertisement
Table of Contents
