Printing On Adhesive Labels - Genicom LA500 User Manual

P r i n t i n g o n A
P r i n t i n g o n A
When printing on adhesive labels you must disable the backward movement of the paper,
because the unsticking of the labels can cause paper jams when the paper is moved backwards.
Proceed as follows:
1. Press the button to put the printer in Set-Up mode.
Set-Up
The display shows MACROS.
2. Press the ↓ button. MACRO X is displayed, where X is the number of the current Macro.
3. Press the ↓ button.
The display shows PROTOCOL.
4. Press the → button until the TEAR/VIEW MODE Option is displayed.
5. Press the ↓ button to pass over to the Values for the Tear/View mode.
6. Press the → or ← button, until No tear/reverse is displayed.
7. Press the
Sel/Save
that the Value has been selected.
8. Press the button to exit the Set-Up mode.
Exit
The message "Save config." appears, indicating that you are going to save your new
setting.
9. To permanently save your choice, press the
It is not necessary to perform the above operation when using the Push-Pull paper path, as all
backwards movements are inhibited with this path. We recommend using the Push-Pull path
when printing on adhesive labels, but note however that the printing of landscape barcodes may
d h e s i v e L a b e
d h e s i v e L a b e
button to set confirm the new setting. An asterisk is displayed to indicate
generate backward movements.
l s
l s
button.
Sel/Save
51