Winegard 2-WAY SATELLITE INTERNET SYSTEM Product Manual page 46

4. screen that appears next will depend on the type of antenna the
The
controller is connected to. The way a calibration is performed is handled
differently between a WX, DS and DT antenna and a SPA and FA type
antenna.
On either event, the calibration's first section shows a live compass heading
and states that if the heading is not within 15 degrees of actual magnetic
heading, then a calibration will need to be performed.
A. WX Models -
If the controller is connected to a WX antenna, the screen states that a
360 degree rotation of the VEHICLE is required to perform a calibration.
Before beginning a calibration, use a handheld compass to determine the
direction the reflector faces when in the stowed position. Most of the time
that direction will be facing towards the back of the vehicle.
i. If the heading displayed is within 15 degrees of the actual heading
from your handheld compass, there is no need to calibrate the
compass. Press "SKIP" to exit the calibration and move to step 5.
ii. If the heading displayed is NOT within 15 degrees of the actual
heading from your handheld compass, the antenna will need to be
calibrated.
To begin the calibration, press the "GO" button.
iii. After the GO button is pressed, the buttons will change to a STOP and
NEXT buttons as seen in the following screenshot.
The two arrows to the right of the screen will rotate showing that a
circle needs to be made.
P a g e |
46