5.2 WX Installation Information
The Winegard WX antenna should be mounted to a secure platform using the rails
provided. The following diagrams show the mounting point dimensions as well as
the wiring panel at the base of the antenna.
1. Mounting points -
All mounting points should be connected to a cross member or secure mounting
point on the vehicle roof or mobile platform. Use 8 – 3 /8 inch x 1 inch (10 mm x
25 mm) Grade 8 bolts with washers and appropriate lock nut.
2. Wiring Bulkhead-
TX and RX cables are F connector terminated and go directly to the modem
Satellite In (Rx) and Satellite Out (Tx) ports.
The ODU power/communication cable is TNC or F connector terminated and
connects the antenna to the Winegard 2-Way Controller ODU port. The picture
below shows the wiring plate. The DC symbol is shown on the wiring plate label
with 48 volts DC and 3.5 amps.
P a g e
|
17