Advertisement
Installation Instructions
Winegard offers the following installation
steps for the Winegard Air 360:
Failure to follow these instructions
could cause damage to the unit
making it inoperable, as well as,
possible damage to the vehicle on
which it is installed.
Step 1 – After selecting a spot on the
vehicle for the antenna, drill at minimum
a 1 inch hole for two coax cables (only
one provided) to run from the antenna to
the Winegard power supply and from the
AM/FM antenna to the AM/FM receiver
(not provided). Do not seal this hole.
Step 2 – Next, connect the coax cable to
the Over-The-Air (OTA) antenna F-Jack
located centrally under the dome. If AM/
FM is desired, connect a coax cable (not
provided) to the F-Jack on the AM/FM
antenna located on the base of the AM/
FM antenna. Route both coax cables
through the 1 inch hole created in step 1.
NOTE: To ensure a reliable signal, it is
recommended to use RG-6 coax no longer
than 30 feet from the roof antenna to the
wall plate.
Be sure to tighten the coax cables
to the F-Jacks (finger tight plus
1/8 turn).
Failure to do so may cause the
signal to become intermittent
or unusable.
Step 3 – On the edge of the flange you
will notice 2 FRONT
labels.
These labels should be facing the front
of the RV on one side and the rear of the
RV on the other.
Step 4 – It is recommended to use Butyl
tape for extra protection under the flange
before screwing to the roof.
NOTE: Before using the supplied
mounting screws, check with your vehicle
manufacturer for any special screw
requirements.
Screw in 6 approved mounting screws
into the 6 mounting holes around the
flange and into the roof.
CAUTION: Do not
overtighten the mounting
screws. This could cause
the plastic flange to break.
Red Wire +12V DC
Red Wire +12V DC
Black Wire Ground
Black Wire
Ground
TV 2
TV 2
Satellite
SATELLITE
TV 1
TV1
Cable In
CABLE IN
RV-0752
TV Antenna
Step 5 – Add approved sealant
completely around the base and over
each screw.
Step 6 – Connect the coax cable attached
to the OTA antenna to the ANT IN F-Jack
input of the Winegard power supply.
TV Antenna
Step 7 – Connect the coax cable
attached to the AM Antenna to the
Audio Extension Cable (CL-FM06). Next
connect this Audio Extension Cable into
the AM/FM receiver.
Min 1" thru Hole
Min. 1" Thru Hole
Audio Extension
Audio Extension
AM Antenna
AM Antenna
Cable (CL-FM06)
Cable (CL-FM06)
6X Mounting Screws
6X Mounting
Screws
(Not Included)
AM/FM Antenna
AM/FM Antenna
Vehicle's
Vehicle Roof
Roof
To AM/FM
TO AM/FM
RECEIVER
Receiver
Advertisement
