Installation; Installing The Antenna - Winegard RZ-7500 User Manual

Installation

Installing the Antenna

Warning: install in dry conditions only! Warning: Install in dry conditions only!
1. Choose a location on the roof of the RV that meets
the following requirements:
▪ Has a minimum roof space of 18.5" x 18.75" for
the antenna
▪ Maintains a minimum clearance of 12" from the
edge of the vehicle
▪ Maintains a minimum clearance of 24" from the
front of the vehicle
▪ Maintains distance from any nearby
obstructions See warning below
2. After confirming that the antenna in its chosen
location meets all requirements, trace around each
base foot. Position the antenna with the coax facing
the rear of the vehicle.
3. Clean the roof area where the base feet will attach
to the roof; do not erase your marks.
4. Apply approved sealant in the areas marked for the
base feet.
5. Align the antenna feet with the areas marked for the
base feet, and place the antenna on the sealant.
6. Install three mounting screws per antenna foot,
and tighten.
I
Warning: nstalling the antenna on or near metal objects may cause signal interference.
For optimal performance install in a location free of obstructions.
Rotate the antenna so that the coax connection is facing the back of the vehicle.
The maximum coaxial length from the roof antenna to the control panel should not exceed
30 feet. The distance from the control panel to TV(s) is not critical.
Winegard Rayzar Automatic Antenna
Front of vehicle
≥12" to edge
of vehicle
Coax connection
facing back of vehicle
Minimum roof space of
18.5" x 18.75"
ANT IN
TV OUT
PARK
CABLE
(CABLE
IN)
12 VDC
Page 2