Cycle/Toggle; Mapped; Loop-Assignable; Switch - pigtronix Infinity Looper User Manual

CHAPTER 6. MIDI 42
A Full MIDI Map is provided on page 47. The behavior of individual
commands (CC: control change) is broken down into 4 types of control:

Cycle/Toggle

Any value of these MIDI CC/Note messages toggles or cycles through
the available options, changing to the next selection.

Mapped

The value (0-127) of these MIDI CC/Note messages sets the value of
the parameter.

Loop-Assignable

Specific values of these MIDI CC/Note messages triggers the action
for Loop 1 Only (0), Loop 2 Only (1), the currently Armed Loop Only
(2), or Both Loops (3).

Switch

The value of these MIDI CC/Note messages determines whether the
message acts like a switch press or delivers a specific type (short or
long) of switch press.
A value of 0 is not pressed, a value of 127 is pressed. For MIDI
controllers that send 127 when pressed and 0 otherwise, this type of
command lets the MIDI footswitch act like the buttons (hold for 2
seconds for a long press, or less for a short press).