Soft-Off By Pwr-Bttn; Pnp/Pci Configurations - Colorful C.945PL User Manual

Available options: [Disabled], [1Min 15Min]

Soft-Off by PWR-BTTN

Pressing the power button for more than 4 seconds forces the system to enter the
Soft-Off state.
Available options: [Delay 4 Sec], [Instant-Off]
CPU THRM-Throttling
This option allows you to adjust the CPU temperature. If the CPU temperature gets to
the temperature you set, CPU frequency will be throttling. The range is 12.5% to
87.5%, increase by 12.5%.
Wake-Up by PCI card
When set to [Enabled], the feature allows your system to be awakened from the
Power saving modes through any event on PCI device.
Available options: [Enabled], [Disabled]
USB KB Wake-up From S3
The item allows the activity of the USB device to wake up the system from S3
(Suspend to RAM) sleep state.
Available options: [Enabled], [Disabled]
USB KB Wake-up From S3
The item allows the activity of the USB Keyboard to wake up the system from S3
(Suspend to RAM) sleep state.
Available options: [Enabled], [Disabled]
Power On by Ring
During Disabled, the system will ignore any incoming call from the modem. During
Enabled, the system will boot up if there's an incoming call from modem.
Available options: [Enabled], [Disabled]
Resume by Alarm
The field is used to enable or disable the feature of booting up the system on a
scheduled time/date.
Primary/ Secondary IDE 0/1: (Default: Disable)
When the Primary/Secondary IDE 0/1 devices are activity, whether cancel PC and
IDE saving mode.
FDD, COM, LPT Port: (Default: Disable)
When the FDD, COM, LPT Port are activity, whether cancel the PC and IDE saving
mode.
PCI PIRQ[A-D]#
This option is for setting PCI PIRQ, default is [Disabled].

PNP/PCI Configurations

This section describes configuring the PCI bus system and PnP (Plug & Play) feature.
PCI, or Peripheral Component Interconnect, is a system which allows I/O devices to
operate at speeds nearing the speed the CPU itself uses when communicating with its
special components. This section covers some very technical items and it is strongly
recommended that only experienced users should make any changes to the default