Page 26
CVN B450M GAMING V14 PWROn After PWR-Fail 藶漞簓靅屜馯炏纸娃 ㄌ 樾嗥繟 Alway Off 堟纸 ㄋAlway On 炏纸 ㄋKeep Last State 狦撑副蕾錆牒 ㄌ Power On By RTC 樾粚炏纸娃 ㄌ 樾嗥繟 Disabledㄋ Enabledㄌ 敱罏 Enabled 太吐烼壽堥呠巿 馯粄纉/粚/夑/鼨ㄌ Super IO Configuration Serial Port 岔娐崡堟 努尞硹奓怸ㄌ 樾嗥繟 ONㄋOFFㄌ...
Chapter 5 English Introduction 5-1 Introduction 5-1-1 Package Contents 1* CVN B450M GAMING V14 Motherboard 2* SATA 6Gb/s cables 1* Driver/Utility disk 1* User's Manual 1* I/O Panel shield The package contents above are for reference only and subject to change without notice,specific please in kind prevail! Colorful company reserves the finally explanatory rights.
CVN B450M GAMING V14 5-2 Hardware Installation This section will guide you through the installation of the motherboard. The topics covered in this section are: Preparing the motherboard Installing the CPU Installing the CPU fan Installing the memory Installing the motherboard...
Page 37
Hardware Installation any violation of the correct installation procedures may cause permanent damages to your motherboard. 4. Press the APU down firmly into the socket and close the lever. As the APU is likely to move while the lever is being closed, always close the lever with your fingers pressing tightly on top of the APU to make sure the APU is properly and completely embedded into the socket.
Page 38
CVN B450M GAMING V14 Use the following procedure to install memory DIMMs into the slots on the motherboard. Note that there is only one gap near the center of the DIMM slot. This slot matches the slot on the memory DIMM to ensure the component is installed properly.
Page 39
Hardware Installation from dust and foreign objects, and promotes correct airflow within the chassis. Before installing the motherboard, install the I/O shield from the inside of the chassis. Press the I/O shield into place and make sure it fits securely. If the I/O shield does not fit into the chassis, you would need to obtain the proper size from the chassis supplier.
Page 40
CVN B450M GAMING V14 Rear panel USB 2.0 Adapter Expansion slots ATX power connectors 24-pin ATXPWR, 8-pin ATX12V These connectors are for an ATX power supply. The plugs from the power supply are designed to fit these connectors in only one orientation.
Page 41
Hardware Installation USB 3.0 connector This connector is for USB 3.0devices. USB2.0 connectors These connectors are for USB 2.0 ports. Connect the USB module cable to any of these connectors, then install the module to a slot opening at the back of the system chassis. These USB connectors comply with the USB 2.0 specification that supports up to 480Mbps connection speed.
Page 42
CVN B450M GAMING V14 Front panel audio connector This connector is for a chassis-mounted front panel audio I/O module that supports either High Definition Audio or AC`97 audio standard. Connect one end of the front panel audio I/O module cable to this connector.
Page 43
Hardware Installation Hard disk drive activity LED 2-pin IDE_LED This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity LED cable to this connector. The IDE LED lights up or flashes when data is read from or written to the HDD. System warning speaker 4-pin SPEAKER This 4-pin connector is for the chassis-mounted system warning speaker.
Page 44
CVN B450M GAMING V14 PCI Express x16 Slots The PCI Express x16 slot is reserved for a graphics or video card. The bandwidth of the x16 slot is up to 8GB/sec. When installing a PCI Express x16 card, be sure the retention clip snaps and locks the card into place.
Page 45
Hardware Installation Clear CMOS PROCEDURE You can clear CMOS by shorting 1-2 pin. Before you clearing the CMOS, following next procedure: 1ㄋTurn off the AC power supply and connect pins 1 and 2 together using the jumper cap. 2ㄋReturn the jumper setting to normal (pin 2) or Remove the jumper cap.
Page 46
CVN B450M GAMING V14 FAN_RGB_HEADER This 4-pin header is for FAN with LED light SPEAK header:SPEAK This SPEAK header is for Speaker serial devices...
Page 47
Hardware Installation M.2 Slot The motherboard has one M.2 slot, support PCI-e x4 and MSATA channel M.2 SSD the Data transmission rate is up to 32Gb/S, support 2242/2260/2280 size SSD and NVMe standard. Please install M.2 SSD correctly in the slot following the following steps: 1.
Page 48
CVN B450M GAMING V14 5-2-4 Back Panel IO Connector Parts PS2 Mouse/ This connector is for a PS2 mouse/ Keyboard Connector Keyboard. LAN Jack The standard RJ-45 jack is for connection to single Local Area Network (LAN). You can connect a network cable to it.
BIOS Setting 5-3 BIOS Setting This chapter introduces how to change the system settings through BIOS settings. Please refer to this chapter for details. The chapter contains the following: Main System Information Advanced Advanced BIOS Features Chipset Chipset Settings Security Security Settings Boot Startup Settings OC Drive OverClock Settings 5-3-1 Enter BIOS Main Menu...
Page 50
CVN B450M GAMING V14 BIOS Setup Program Function Keys < ⓦⓨ > Upward and downward move to select a setup menu a setup menu < ⓥ ⓧ > To the left and right move to select < Enter > Execute command or enter a menu <...
Page 51
BIOS Setting Main menu The main menu shows the set item category provided by BIOS. You can use the direction key to select different items. The hint information for the selected project is displayed at the bottom of the screen. Submenu If you find a pointer to the right in a region on the left (as shown in the figure above), this means that this item is attached to the submenu.
Page 52
CVN B450M GAMING V14 OC Drive OverClock Settings This menu can be used to overclock and optimize the performance of the system. 5-3-3 Main System Information Advanced Chipset Main Security Boot OC Drive BIOS Information BIOS Vendor American Megatrends Core Version 5.13...
Page 53
BIOS Setting System Time Set the time the time format is<hour><minute><second> 5-3-4 Advanced Advanced BIOS Features Boot Security OC Drive Main Advanced Chipset ACPI Settings AMD fTPM configuration CPU Configuration →←Select Screen SATA Configuration Up/Down:Choose Item USB Configuration Enter/ Click: Select Onboard Device Configuration +/-: Change Opt Advanced Power Management...
Page 54
CVN B450M GAMING V14 AMD fTPM configuration AMD fTPM switch Turn on or off the AMD fTPM switch. FTPM is a TPM module launched by AMD.TPM (Trusted Platform Module) security chip is a kind of security chip that conforms to TPM (Trusted Platform Module) standard.
Page 55
BIOS Setting C6 Mode Turn on or off C6 mode. The C6 mode is the energy saving mode of AMD APU, which needs to be shut down when overclocking. Options:Disabled, Enabled. SATA Configuration SATA Setup SATA 1-4 Display the connections of the SATA1-4 ports. USB Configuration (USB settings) Legacy USB Support Open or close the traditional USB device function.
Page 56
CVN B450M GAMING V14 Device reset time-out This option sets the longest time needed to store device reset on the USB2.0 bus. During this time, EFI will check whether the storage device can accept instructions. If the timeout is over, the storage device is considered to be wrong.
Page 57
BIOS Setting G3 Wake on Lan Support for network wake-up after power failure.Options: Disabled, Enabled. PWROn After PWR-Fail Set up the boot function after abnormal power failure. Options: Alway Off, Alway On, Keep Last State. Power On By RTC Set the function of timing boot. Options: Disabled and Enabled. If you select "Enabled", the specific wake-up date / time / minute / sec will be popped up.
Page 58
CVN B450M GAMING V14 5-3-5 Chipset chipset settings Boot Security OC Drive Main Advanced Chipset South Bridge North Bridge →←Select Screen Up/Down:Choose Item Enter/ Click: Select +/-: Change Opt F1: General Help F7: Previous Values F9: Optimized Defaluts F10: Save&Reset ESC: Exit Version 2.18.0043.Copyright (c) 2018 American Megatrends,Inc...
Page 59
BIOS Setting IGFX Multi Monitor Set up multi monitor display function.Options:Disabledㄋ Enabled. Primary Video Device Display priority settings.Options:IGD / Hybrid_CrossFire Video (board graphics card / mixed fire), NB PCIe Slot Video (North Bridge PCIe graphics card). Integrated Graphics Turn on and off the integrated graphics card.Options:Disabled (close), Force (manual), Auto (automatic).
Page 60
CVN B450M GAMING V14 3. when the "Enter" key is pressed, the "Confirm New Password" window will appear, and again the password is entered to confirm the correct password. If the "Invalid Password" prompt information is presented, a mistake is entered when the password is confirmed, and reoperation is required.
Page 62
CVN B450M GAMING V14 5-3-8 OC Drive OverClock Settings DRAM Voltage Set DRAM voltage. VDDR Voltage Set VDDR voltage. CPU Fid Boost CPU frequency doubling adjustment, if the CPU allows to adjust the frequency doubling, this can take effect, and can adjust the CPU frequency doubling in a certain range.
Page 63
BIOS Setting RAS/ CAS Delay tRCD This project is used to select the time lag between RAS (Row Address Strobe) and CAS (Column Address Strobe) when reading and writing data at the same bank. The shorter the set period, the faster the DRAM will run. ROW Precharge Time tRP This project is used to control how long after the Precharge command is sent out by SDRAM, the command must not be sent...
Page 64
CVN B450M GAMING V14 instructions (REF instructions) twice to the same row unit in the same bank. The smaller the tRRD, the better. The lower latency means that the next bank can be activated faster and read and write. However, due to the need for a certain amount of data, too short delay will cause continuous data expansion.
Page 65
The material in this document is the intellectual property of Colorful Technology and Development CO, LTD. We take every care in the preparation of this document, but no guarantee is given as to the correctness of its contents. Our products are under continual improvement and we reserve the right to make changes without notice.
Page 66
Or our engineer, send the follow information to us! Customer name Purchase date Contacts Contact phone Contact address Product model Product SN Dealer name Dealer phone Dealer address Website: www.colorful.cn Service hotline: +86400-678-586...
Need help?
Do you have a question about the CVN B450M GAMING V14 and is the answer not in the manual?
Questions and answers