Figure 2-21: Mp-124 In A 19-Inch Rack With Mdf Adaptor - AudioCodes MediaPack MP-11 Series Installation Manual

3. Connect the wire-pairs at the other end of the cable to a male 50-pin Telco connector
(not supplied).
4. Insert and fasten the male connector to the female 50-pin Telco connector on the
MP-124 rear panel (labeled Analog FXS Lines 1-24).
5. Connect the telephone lines from the MDF adaptor block to a fax machine, modem, or
telephones by inserting each RJ-11 connector on the 2-wire line cords of the POTS
phones into the RJ-11 sockets on the front of an MDF adaptor block, as shown in the
figure below.

Figure 2-21: MP-124 in a 19-inch Rack with MDF Adaptor

Installation Manual 30
MediaPack Series
Document #: LTRT-59813