Table of Contents
Advertisement
1. Every construction heater should be inspected before each use, and at least
annually by a qualified service person.
2. The hose assembly shall be visually inspected prior to each use of the heater. If it is
evident there is excessive abrasion or wear, or the hose is cut, it must be replaced
prior to the heater being put into operation. The replacement hose assembly shall be
that specified by the manufacturer.
3. The appliance must be kept clear and free from combustible materials, gasoline and
other flammable vapors and liquids.
4. The flow of combustion and ventilation air must not be obstructed. Be sure to check
the fan assembly and ensure that the motor and blade are operating properly.
5. Compressed air should be used to keep components free of dust and dirt build up.
Note: Do not use the compressed air inside any piping or regulator components.
MAINTENANCE:
- 6 -
Advertisement
Table of Contents
