May 20, 2015 - Palo Alto Networks COMPANY CONFIDENTIAL
Chapter 2
Installing the Hardware
This chapter describes how to install the PA-200 firewall. For more information, refer to the
following topics:
•
"Tamper Proof Statement" on page 9
•
"Before You Begin" in the next section
•
"Connecting Cables to the Device" on page 10
•
"Connecting Power" on page 10
Tamper Proof Statement
To ensure that products purchased from Palo Alto Networks have not been tampered with
during shipping, verify the following upon receipt of each product:
•
The tracking number provided to you electronically when ordering the product matches
the tracking number that is physically labelled on the box or crate.
•
The integrity of the tamper-proof tape used to seal the box or crate has not been
compromised.
•
The warranty seals on the device itself do not show evidence of tampering. Being a
modular system, please note that the PA-7050 does not have a warranty seal.
Before You Begin
•
Verify that the intended location has adequate air circulation and meets the temperature
requirements. Refer to "Environmental Specifications" on page 14.
•
Unpack the device.
•
Verify that power is not connected to the firewall.
•
Allow clear space on all sides, back, and top of the firewall to allow for proper cooling. Do
not stack PA-200 firewalls.
Palo Alto Networks
Installing the Hardware • 9