Table of Contents
Advertisement
|
|
|
|
Connect the External LDI Interface to the Server (optional)
Configure the Drive to the Server, Switch, or Hub
|
|
26
IBM TotalStorage Ultrium Tape Drive
__ 2. Run the appropriate Fibre Channel attachment verification procedure from
your server (for instructions, refer to the IBM Ultrium Device Drivers
Installation and User's Guide). If a SCSI error occurs, refer to "Using Sense
Data" on page 79.
Use this step only if your enclosure requires an LDI interface.
To perform a checkout of the drive, connect the enclosure's external LDI cable to
the server (for the location of the external LDI connector, refer to the
documentation for the enclosure).
To configure the SCSI drive to the server, or to configure the Fibre Channel drive
to a server, switch, or hub, refer to the documentation for that server, switch, or
hub.
The drive is now ready for use.
Advertisement
Table of Contents
