Function Code P: Enable Post Error Reporting; Function Code U: Disable Post Error Reporting - IBM TotalStorage Ultrium T800 Operator's Manual

Function Code P: Enable Post Error Reporting

When selected, deferred-check conditions are reported to the host. Therefore,
temporary errors are reported in the sense data. This selection is normally used as
a request from support personnel. Default is
1. Place the drive in maintenance mode. For instructions, see "Entering
Maintenance Mode" on page 32.
2. Press and hold the Unload Button for three seconds while
SCD. The SCD changes to

Function Code U: Disable Post Error Reporting

When selected, turns Post Error reporting off. Deferred-check conditions
(temporary errors) are NOT reported to Host (normal mode of drive operation).
U
Default is
1. Place the drive in maintenance mode. For instructions, see "Entering
Maintenance Mode" on page 32.
2. Press and hold the Unload Button for three seconds while
SCD. The SCD changes to
P
then exits maintenance mode.
(disabled).
U
then exits maintenance mode.
U
(disabled).
U
appears in the
P
appears in the
45
Operating