Table of Contents
Advertisement
Figure 2-2. Example of connecting one SAS device to the server
Figure 2-3. Example of connecting the SAS device to two servers
Connecting the USB interface cable (optional)
|
|
|
|
|
|
|
|
|
|
|
|
5
4
1
Tape drive
2
SAS connector
3
SAS cable
5
5
4
1
Tape drive
2
SAS connectors
3
SAS cables
4. Ensure the host adapter and the server are configured correctly for a SAS bus
operation. Refer to the host adapter and server documentation for instructions.
If the tape drive was ordered with Feature Code 5760, it has a single USB 3.0 port
and a single SAS port. To use SAS connectivity, refer to "Connecting the SAS bus
cable" on page 2-4.
The USB architecture does not support multiple tape drives connected to a single
host USB port. Each tape drive is required to have a dedicated USB connection to
the host. Connecting the tape drive to a USB hub is not supported. It is
recommended that a USB 3.0 compatible cable is used to connect the host to the
tape drive. Whether a USB 3.0 or USB 2.0 compatible cable is used to connect this
device, it must be 3 meters or less in length.
To connect the cable:
1. Ensure that the tape drive is powered OFF.
3
2
4
5
4
3
2
3
2
4
5
1
SAS host adapter card
Server
1
SAS host adapter card
Servers
Chapter 2. Installation
2-5
Advertisement
Table of Contents
