Control Panel Menus - Martin MAC Viper Profile User Manual

Control panel menus

Applicable when running MAC Viper Profile firmware version 1.3.0.
Menu level 1 Menu level 2
DMX ADDRESS 1 – XXX
BASIC
CONTROL MODE
EXTENDED
FIXTURE ID 0 – 9999
PAN/TILT
SPEED
PERSONALITY
DIMMER CURVE
FOCUS
TRACKING
GOBO 3 FX
RANGE
30
Menu level 3 Menu level 4
User-settable fixture ID number
PAN INVERT ON/OFF
TILT INVERT ON/OFF
NORMAL
FAST
PAN/TILT
SLOW
FOLLOW P/T
NORMAL
EFFECT
FAST
SLOW
LINEAR
SQUARE LAW
INV SQ LAW
S-CURVE
DISABLED
NEAR
MEDIUM
FAR
POSITION OFF,
START FX POS POSITION 1 ...
POSITION 8
POSITION OFF,
END FX POS POSITION 2 ...
POSITION 9
Table 2: Control menus
MAC Viper Profile User Guide
Notes (Default settings in bold print)
DMX address (default address = 1). The
DMX address range is limited so that the
fixture will always have enough DMX
channels within the 512 available.
16-bit basic DMX mode with 2-channel
(coarse and fine) control of breakup and
aerial wheel gobo indexing and speed, pan
and tilt
16-bit extended DMX mode with basic
mode features plus fine control of dimmer,
zoom and focus. Five channels are also
reserved for future effects.
0
Reverse DMX pan control: right → left
Reverse DMX tilt control: down → up
Normal speed pan and tilt
Optimize pan/tilt movement for speed
Optimize pan/tilt movement for
smoothness
Effects speed follows the speed setting
applied to pan and tilt via DMX or in
control menu
Normal effects speed
Optimize effects movement for speed
Optimize effects movement for
smoothness
Optically linear dimming curve
Square law dimming curve
Inverse square law dimming curve
S-curve (fixture emulates incandescent
lamp voltage linear RMS dimming curve)
Disables zoom focus linking
Enables zoom focus linking, optimized for
short-throw projection (5 - 10 m)
Enables zoom focus linking, optimized
for medium-throw projection (10 - 20 m)
Enables zoom focus linking, optimized for
long-throw projection (20+ m)
Defines FX wheel (wheel 3) start position.
Default = POSITION 5.
Defines FX wheel (wheel 3) final position.
Default = POSITION 9.