Overview Of The 100-240 Vac Power Supply Unit Aps1000W; Specifications - NETGEAR M6100 Hardware Installation Manual

Overview of the 100-240 VAC Power Supply Unit
APS1000W
The following figure shows the 100-240 VAC UL-listed accessory power supply unit (PSU).
The power supply bay in an M6100 series switch can accommodate up to four hot-swappable
PSUs.
Front
Figure 4. Power supply unit APS1000W
The front panel on each PSU provides a handle for insertion and removal of the unit. A
cooling fan draws air in through the rear vents on the PSU and exhausts the air through the
front vents of the switch. Airflow through the PSU is independent of the airflow through the
rest of the switch.
WARNING:
Field operators must not attempt to open the PSU enclosure for any
reason; the PSU does not contain user-serviceable parts. If the PSU
fails, return the defective PSU for repair or replacement.

Specifications

The APS1000W PSU functions from 90V to 264V and 47 Hz to 63 Hz AC input. Each PSU
provides 700W to the system if the AC input is in the 110V low-line output power range and
1000W to the system if the AC input is in the 220V high-line output power range.
More installed PSUs are needed to support the load if the low-line power range is used to
power the switch. The software determines the maximum available power required for the
switch and enables the modules accordingly.
NETGEAR M6100 Switch Chassis
Back
Power Supply Units
18