NETGEAR M6100 Hardware Installation Manual page 39


To ground the chassis:
Locate the grounding point on the back of the chassis.
1.
Strip 0.5 inch (1.2 cm) of insulation from the stranded copper wire cable.
2.
Insert the stripped wire into the cable lug.
3.
CAUTION:
Be sure that no copper is visible between the lug and the cable insulation.
Crimp the lug onto the cable according to the manufacturer's specifications.
4.
Insert the screws through the lug and into the grounding point on the back of the chassis.
5.
Connect the other end of the wire to a known reliable earth ground point at your site.
6.
NETGEAR M6100 Switch Chassis
Install an M6100 Series Chassis
39