Blocking Calls From Unregistered Sas Users; Configuring Sas Emergency Calls - AudioCodes MediaPack Series MP-11x User Manual

User's Manual

27.5.4 Blocking Calls from Unregistered SAS Users

To prevent malicious calls, for example, service theft, it is recommended to configure the
feature for blocking SIP INVITE messages received from SAS users that are not registered
in the SAS database. This applies to SAS in normal and emergency states.

To block calls from unregistered SAS users:
1. Open the SAS Configuration page (Configuration tab > VoIP menu > SAS
Alone Survivability).
2. From the 'SAS Block Unregistered Users' drop-down list, select Block.
3. Click Submit to apply your changes.

27.5.5 Configuring SAS Emergency Calls

You can configure SAS to route emergency calls (such as 911 in North America) directly to
the PSTN through its FXO interface. Thus, even during a communication failure with the
external proxy, enterprise UAs can still make emergency calls.
You can define up to four emergency numbers, where each number can include up to four
digits. When SAS receives a SIP INVITE (from a UA) that includes one of the user-defined
emergency numbers in the SIP user part, it forwards the INVITE directly to the default
gateway (see 'SAS Routing in Emergency State' on page 295). The default gateway is
defined in the 'SAS Default Gateway IP' field, and this is the device itself. The device then
sends the call directly to the PSTN.
This feature is applicable to SAS in normal and emergency states.

To configure SAS emergency numbers:
1. Open the SAS Configuration page (Configuration tab > VoIP menu > SAS > Stand
Alone Survivability).
2. In the 'SAS Default Gateway IP' field, define the IP address and port (in the format
x.x.x.x:port) of the device (Gateway application).
Note:
Version 6.6
The port of the device is defined in the 'SIP UDP/TCP/TLS Local Port' field in
the SIP General Parameters page (Configuration tab > VoIP menu > SIP
Definitions > General Parameters).
313
27. SAS Configuration
Stand
MP-11x & MP-124