Epson Runsense SF-710 User Manual page 61

SF-710/510/310 User Manual
You are returned to the measurement screen.
G
Complete the settings.
Hold down A.
The measurement screen is displayed.
H
Start measuring.
Press C.
c
Important:
❏ The Waypoint screen is not displayed by
default while measuring. To check the
information for Waypoint while measuring,
change the screen configuration so that the
waypoint screen is displayed.
"Screen" on page 115
U
❏ See the following pages for information on
viewing the Waypoint screen.
"Screen pattern table" on page 116
U
❏ If an error condition continues, due to the
characteristics of GPS, the waypoint may not
be able to display the exact direction. If this
occurs, try moving a few tens of metres. Make
sure you pay attention to your surroundings
if you check the direction while moving.
I
As you approach the specified point,
an alarm sounds.
The alarm sounds in the following conditions.
Errors may occur due to the surrounding
environment.
Activity Type
Run/Walk
Bike
Measure
Range
When within a range of
10 m in radius
When within a range of
100 m in radius
c
Important:
In environments that do not allow GPS
positioning, the alarm does not sound because the
Waypoint function is unavailable. Use the
Waypoint function in environments that allow
GPS positioning.
61