Setting And Measuring Waypoints (Waypoint Function); Registering Waypoints - Epson Runsense SF-710 User Manual

SF-710/510/310 User Manual
Setting and Measuring
Waypoints (Waypoint
Function)
The waypoint function acquires the latitude and
longitude for Current position, and register to the
device as a point.
You can register waypoints to the device by using the
buttons while measuring. By specifying the registered
point, you can display the directions to the point, the
distance in a straight line, and the difference in
elevation. As you approach the specified point, an alarm
sounds. This is not a navigation function.
The Waypoint function is only available for the SF-710.
Note:
By using the PC application (Run Connect), you can setup
Waypoints from your computer.
When setting up from your computer, you can register
waypoints on the map.
"Setting the Waypoint Function (SF-710 only)" on
U
page 99
Operation buttons

Registering waypoints

A
Display the measurement screen.
Press C on the time screen.
Measure
GPS positioning starts, and the measurement
screen is displayed once positioning is complete.
"Specifying a GPS (GPS Positioning)" on
U
page 29
B
Start measuring.
Press C.
C
Stop measuring when you reach a
point you wish to register as a
Waypoint.
Press C while measuring.
D
To register the Waypoint.
Hold down A.
59