Setting A Pace And Measuring (Target Pace Function) - Epson Runsense SF-710 User Manual

SF-710/510/310 User Manual
Setting a Pace and
Measuring (Target Pace
Function)
You can use this function to sound an alarm if you fall
behind the pace set as the target pace during measuring.
Set your target time for one kilometre/mile (target pace)
and the range at which the alarm sounds when you fall
behind that target pace.
Note:
By using the PC application (Run Connect), you can setup
the Target Pace from your computer.
When setting up from your computer, you can customise
your target pace (SF-710 only).
"Setting the Target Pace Function (SF-710 only)" on
U
page 96
Operation buttons
A
Display the measurement screen.
Press C on the time screen.
Measure
GPS positioning starts, and the measurement
screen is displayed once positioning is complete.
"Specifying a GPS (GPS Positioning)" on
U
page 29
B
Displays the Measure set. menu.
Hold down B on the measurement screen.
C
Select Target Pace.
Use C/D to select, and then press A.
D
Select an empty setting.
Use C/D to select, and then press A.
When this is already set, select one of SETTING
01 to 03.
E
Set the target time for one kilometre/
mile.
Use C/D to set, and then press A.
57