Table of Contents
Advertisement
Signal Connections
The onAir IP Panel 1 can receive a DMX, Art-Net™, sACN, or a wireless Lumenradio CRMX™ signal. The
product has 2 Seetronic Etherkon-compatible through ports and 5-pin DMX in and out ports. If using other
compatible products with this product, the user can control each individually with a single controller.
Control Personalities
The onAir IP Panel 1 uses a 5-pin DMX data connection, Art-Net™, sACN, or wireless CRMX™ for its 14
control personalities, ranging from 1Ch to 16Ch.
•
Refer to the
Operation
personalities.
•
The
Control Channel Assignments and Values
control personalities.
If the user is not familiar with or need more information about DMX standards or the DMX
cables needed to link this product to a DMX controller, download the DMX Primer from the
Chauvet website: www.chauvetprofessional.com.
DMX Linking
The onAir IP Panel 1 can be linked to a DMX controller using a 5-pin DMX connection or a CRMX™
connection. For more information about DMX, read the DMX primer at:
https://www.chauvetprofessional.com/wp-content/uploads/2016/06/DMX_Primer.pdf.
Remote Device Management
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate
bi-directionally along existing DMX cabling. Check the DMX controller's User Manual or with the
manufacturer as not all DMX controllers have this capability. The onAir IP Panel 1 supports RDM protocol
that allows feedback to make changes to menu map options.
Art-Net™ Connection
Art-Net™ is an Ethernet protocol that uses TCP/IP which transfers a large amount of DMX512 data using
an ethernet connection over a large network. An Art-Net™ protocol document is available from
www.chauvetprofessional.com.
Art-Net™ designed by and copyright Artistic Licence Holdings Ltd.
sACN Connection
Also known as ANSI E1.31, streaming ACN is an Ethernet protocol that uses the layering and formatting of
Architecture for Control Networks to transport DMX512 data over IP or any other ACN compatible network.
Ethernet Connection Diagram
Computer/
controller
(running Art-Net™
or sACN protocol)
8
chapter to learn how to configure the onAir IP Panel 1 to work in these
section provides detailed information regarding the
Switch or router
onAir IP Panel 1
To other Art-Net™ or sACN devices
onAir IP Panel 1 User Manual Rev. 3
Setup
Advertisement
Table of Contents
