Parameter Menu (M2) - Vacon nx User Manual

CONTROL KEYPAD
7.3.2

Parameter menu (M2)

Parameters are the way of conveying the commands of the user to the frequency converter. The parameter
values can be edited by entering the
is visible on the first line of the display. The value editing procedure is presented in Figure 7-5.
Menu button right
Push the
group desired by using the
its parameters. Use again the
can proceed in two different ways: Pushing the
this, the parameter value starts to blink. You can now change the value in two different manners:
Just set the new desired value with the
1
button
. Consequently, the blinking stops and the new value is visible in the value field.
Push the Menu button right
2
editing manner may come in handy, when a relatively greater or smaller value than that on the
display is desired. Confirm the change with the
The value will not change unless the Enter button is pushed. Pressing the
back to the previous menu.
Several parameters are locked, i.e. uneditable, when the drive is in RUN status. If you try to change the
value of such a parameter the text
stopped in order to edit these parameters.
The parameters values can also be locked using the function in menu M6 (see Chapter Parameter lock
(P6.5.2)).
Main menu
You can return to the
The basic application package "All in One+" includes seven applications with different sets of parameters.
You will find the parameter lists in the Application Section of this manual.
Once in the last parameter of a parameter group, you can move directly to the first parameter of that group
Browser button up
by pushing the
See the diagram for parameter value change procedure on page 84.
24-hour support +358 (0)201 212 575 • Email: vacon@vacon.com
Parameter Menu
Parameter Group Menu (G#)
once to move into the
Browser buttons
and push the
Browser buttons
to find the parameter
Menu button right
Browser buttons
once again. Now you will be able to edit the value digit by digit. This
*Locked*
will appear on the display. The frequency converter must be
anytime by pressing the
.
Main Menu
from the when the location indication M2
Menu button right
(P#)
you want to edit. From here you
takes you to the edit mode. As a sign of
and confirm the change with the
Enter button
.
Menu button left
for 3 seconds.
vacon • 83
. Locate the parameter
again to enter the group and
Enter
Menu button left
takes you
7