Resetting Welding Parameters To The Factory Settings - EWM Pico 180 Operating Instructions Manual

Rectifying faults

Resetting welding parameters to the factory settings

Display
7.4 Resetting welding parameters to the factory settings
All customised welding parameters that are stored will be replaced by the factory
settings.
Display
36
Setting/selection
Calibration
The machine will be calibrated for approx 2 seconds each time it is switched on.
Exit the menu
Exit
Machine configuration
Settings for machine functions and parameter display
Dynamic power adjustment
20 A Setting for 20 A mains fuse protection (factory setting)
16 A Setting for 16 A mains fuse protection
10 A Setting for 10 A mains fuse protection
Service menu
Modifications to the service menu may only be carried out by authorised maintenance
staff!
Software version of the machine control
Version display
0
1
Setting/selection
Calibration
The machine will be calibrated for approx 2 seconds each time it is switched on.
Initialising
All customised welding parameters that are stored will be replaced by the factory
settings.
NOTE
Figure 7-3
0
1
099-002003-EW501
19.09.2011