Ethernet; Connecting Audio Device; Connecting Power Cord - Advantech IPPC-9151G User Manual

2.1.11

Ethernet

Connect the Ethernet cable to LAN port. Note: If the distance between the network
cable and the device is to far it will result in the network cannot be connected. Add a
HUB to enhance the network signal as needed.
LAN LED Indicators:
LAN mode
LAN1 LED
LAN2 LED
2.1.12

Connecting Audio Device

The audio interface includes three jacks: line-in, line-out and Mic-in. Attach the
device when needed.
2.1.13

Connecting Power Cord

Remove the power cord bracket, then plug in the standard power cord. Replace the
bracket and fasten the screws. Note: Pay attention to the input voltage of the power
supply.
LAN LED
Off when connection error occurs; Linked (On)/
LED1 (right)
Active (Blinking)
LED2 (left) 100 Mbps(On)/10 Mbps (Off)
LED2 (left) 1000 Mbps (On)
Off when connection error occurs; Linked (On)/
LED2 (right)
Active (Blinking)
LED2 (left) 100 Mbps(On)/10 Mbps (Off)
LED2 (left) 1000 Mbps (On)
17 IPPC-9151G/9171G User Manual