Bar Code Location - Kodak digital science 7500 Installation Instructions Manual

Bar code location

3-52
Bar code location defines whether the bar codes are to be located on
the front or rear of the document(s).
The default for all modes is Front.
The options are:
— Front— the bar code reader attempts to detect bar codes on the
front side of each document.
— Rear— the bar code reader attempts to detect bar codes on the
rear side of each document.
NOTE: This option is only valid when using a duplex Scanner 5500/
7500. Also, if bar codes are located on the side opposite the
side defined as the bar code location, then the bar codes will
not be detected.
Select Bar Code Location from the Bar Code Reader menu.
Mode Number: 01 Mode Name: MODE01
Mode Configuration
Single
Index Format
6006
IA Field Width
3111
Level Rules
Supprs
IA Display Format
FthenR Adjoining IA
None
Batching
Off
Length Monitor
Off
Skew Monitor
NA NA
Footswitch
Save & End Session
Save & Prev Menu
Select the side of the document(s) on which bar codes will be
placed.
Press Enter.
Item #: 13.9
Patch Reader Off
COIN2 Port Select n/a
OCR n/a
Bar Code Reader Off
Printr Controller Supprs
Front Printer Off
Rear Printer Off
Mode Name MODE0
Overrides No Sav
Don't Save & End Session
Don't Save & Prev Menu
Bar Code Reader
On/Off
Bar Code Type
Codes Per Document
Minimum Code Length
Maximum Code Height
Scan Direction
Code Quality
Confirmation Tone
Bar Code Location
Previous Menu
Bar Code Location
Front
Rear
Previous Menu
A-61074 April 1997