Kodak digital science 7500 Installation Instructions Manual page 83

Rear printer
3-62
Use the arrow keys to increase or decrease the current distance:
— The left arrow key will decrease the value in 0.125 inch or 1 mm
increments.
— The right arrow key will increase the value in 0.125 inch or 1 mm
increments.
— The down arrow key will decrease the value in 1.250 inch or
20 mm increments.
— The up arrow key will increase the value in 1.250 inch or 20 mm
increments.
Press Enter .
NOTE: The rear printer is an accessory which must be installed and
enabled by your Field Engineer.
Rear printer defines the options required when using the rear printer
accessory.
Select Rear Printer from the Mode Configuration window.
Mode Number: 01 Mode Name: MODE01
Mode Configuration
Single
Index Format
6006
IA Field Width
3111
Level Rules
Supprs
IA Display Format
FthenR
Adjoining IA
None
Batching
Off
Length Monitor
Off
Skew Monitor
NA NA Footswitch
Save & End Session
Save & Prev Menu
The following pages provide instructions on how to define the rear
printer options. When the rear printer definitions are complete, you
will automatically be returned to this window.
To close the Rear Printer menu:
Select Previous Menu . Proceed to make any additional mode
configuration definitions.
NOTE: If the rear printer was not defined as Present during
Accessory Configuration, the following message will appear:
The accessory that you requested is not enabled in
Accessory Configuration.
Press Enter to clear the message.
Exit from Mode Configuration; refer to the section entitled, Exiting
Mode Configuration .
Contact your Field Engineer to install and enable this accessory.
Item #: 16.0
Patch Reader Off
COIN2 Port Select n/a
OCR n/a
Bar Code Reader Off
Printr Controller Supprs
Front Printer Off
Rear Printer Off
Mode Name MODE0
Overrides No Sav
Don't Save & End Session
Don't Save & Prev Menu
Rear Printer
On/Off
Print Definition
Vertical Start Print Position
Previous Menu
A-61074 April 1997