Length Monitor; Patch Reader; Bar Code Reader; Bar Code Test - Kodak 500 User Manual

3-8
F50 Patch Reader On/Off*
Allows you to enable/disable the Patch Reader. Enter 1 to enable
or 0 to disable.
F53 Patch Reader Confirmation Tone On/Off*
Allows you to enable/disable the confirmation tone that informs
you if the Patch Reader has successfully read a patched docu-
ment. Enter 1 to enable or 0 to disable.
F54 Omit Patch Reading on Next Document On/Off*
Allows you to inhibit patch reading on the next document scanned.
Normal patch reading resumes with subsequent documents. Enter
1 to enable or 0 to disable.
F55 Patch Test*
Allows you to test for patch position and patch quality. The test
result will indicate: T-Patch, 2-Patch, 3-Patch, or Patch Not Read.
F60 Bar Code Reader On/Off†
Allows you to enable/disable the Bar Code Reader. Enter 1 to
enable or 0 to disable.
F63 Bar Code Reader Confirmation Tone On/Off†
Allows you to enable/disable the confirmation tone that informs
you if the Bar Code Reader has successfully read a bar code
document. Enter 1 to enable or 0 to disable.
F64 Omit Bar Code Reading on Next Document On/Off†
Allows you to inhibit bar code reading on the next document
scanned. Normal bar code reading resumes with subsequent
documents.
F65

Bar Code Test†

Allows you to test for bar code position, bar code quality and bar
code read rate.
F70 Length Monitor On/Off
Allows you to enable/disable the length monitor which monitors
the length of the document(s) scanned against predefined mini-
mum/maximum allowable lengths. Messages and/or confirmation
tones indicate if the document is shorter/longer than the pre-
defined minimum/maximum.
* The Patch Reader is an accessory.
† The Bar Code Reader is an accessory.
A-61408 September 1995