Kodak EasyShare 5500 Start Here

Start Here
Unpack Printer
IMPORTANT: Do not connect the USB cable to the printer until
instructed during software installation.
EasyShare 5500
a) See box flaps for unpacking
All-in-One Printer
instructions.
b) Remove all orange shipping
tape from the printer.
Print
Copy
Scan
Fax
1
Install Control Panel
a) If not preinstalled, insert
the control panel overlay,
top end first.
Box Contents
On/Off Phonebook Attention Cancel
abc def Copy Rotate
ghi
jkl mno Menu Start
pqrs tuv wxyz Fax Photo Zoom
Symbols Space Scan Transfer
b) Press down on all edges of
Control Panel Overlay Two-Sided Printing Sample Photo the overlay until it snaps
(may be pre-installed) Accessory Paper into position.
2
Sample Plain Printhead Black Ink
Insert Two-Sided Printing Accessory
Paper Cartridge
a) Remove the rear access door.
Color Ink Power Supply Software CD
Cartridge and Adapter and Brochure
b) Insert the two-sided printing
accessory by rotating it
towards you and engage the
lower guide pins.
Identify Main Components
c) Press in until you hear the
duplexer click into position.
Scanner glass
Printer access
door
Memory card
Output
light
tray
Paper-width
guide
Camera card slots
3
USB port/ Load Paper
Main tray Camera input
Photo tray light a) Load photo paper into the photo tray.
Paper-length
Photo tray
guide
1) Lift the photo tray lid until it
remains standing without
Lid
support.
Rear access
door 2) Insert the photo paper glossy
USB port
side down.
Power
connector
IMPORTANT: Do not overload
the photo tray. Max 20 sheets.
*1K1222* *B*
*1K1222* *B*
1K1222 B
8 9
Install Windows Software
Calibrate Printer
IMPORTANT: Make sure that the photo tray is pushed in. The photo
IMPORTANT: Do not connect the USB cable to the printer until
tray light should be lit.
instructed during software installation.
a) Press Start. Wait two minutes
for the calibration sheet to print.
a) Load the Kodak EasyShare
CD into the CD-ROM drive.
If instructions do not appear,
click Start, then Run. Select
Tip: If the calibration sheet
CD-ROM drive and type
does not print properly, see
setup.exe, then press ENTER.
the Troubleshooting section
in this setup poster.
For the latest updates, visit
www.kodak.com/go/downloads
b) Remove the calibration sheet
from the output tray. Place it
face down and align to the left,
back corner of the scanner glass,
as shown.
b) Follow the on screen prompts
to install the AiO Software.
IMPORTANT: The blue arrow in the corner of the calibration sheet
must point to the registration marks as shown.
c) Connect the printer to
the USB port. Click Next
and follow the on screen
prompts.
c) Lower the scanner lid and
press Start. Remove the (10cm x 15cm) 4x6
sheet from the scanner glass If prompted, re-boot your
When the calibration is computer.
complete.
4x6
d) When the EasyShare AiO dialog box appears, close the window.
Vista
d) Lift the photo tray lid, then slide the
photo tray toward you to return to
main tray operation. The photo tray
light will turn off.
Eastman Kodak Company
The Bluetooth® trademarks are
Rochester, NY 14650 U.S.A.
owned by the Bluetooth SIG, Inc.
© Eastman Kodak Company, 2007
MC/MR/TM: Kodak, EasyShare. Printed in the U.S.A.
3) Push the photo tray in
until it clicks into place.
NOTE: You can only print to
the photo tray when the photo
tray is pushed in.
4) Lower the photo tray lid.
b) Load plain white paper into the main tray.
1) 2)
On/Off Phonebook 1 2 3 EasyShare 5500 Attention Cancel
4 abc def Copy Rotate
ghi jkl 5 mno 6 Start
7 pqrs 8 9 Fax Menu Photo 3) 4)
* tuv 0 wxyz Zoom
Symbols # Space Scan Transfer
4
Install Printhead
IMPORTANT: The printhead
is fragile. Handle carefully.
a) Lift the printer access door.
Make sure the orange tape
is removed from the carriage.
b) Remove the printhead from
it's bag.
IMPORTANT: Insert the
printhead immediately
upon opening sealed bag.
c) Pull on the orange tab to
remove the protective
retainer.
Install Macintosh Software
a) Connect the USB cable to
the printer and your
computer.
b) Load the Kodak EasyShare CD
into the CD-ROM drive. The
Kodak 5000 AiO Printer Software
installer window should be
displayed. If not, double click
the Kodak 5000 AiO Printer
Software CD icon on the desktop.
Follow the on screen prompts.
For the latest updates, visit
www.kodak.com/go/downloads
c) Double click the Install
Software.mpkg icon and
follow the on screen prompts.
d) Choose a destination
for the installed software.
Click Continue and follow
the on screen prompts.
e) Click Install to perform
a basic installation of the
software. Click Continue
and follow the on screen
prompts.
XP
f) Click Restart to complete
the installation.
Windows® is a registered trademark
of Microsoft Corporation
Macintosh® is a registered
trademark of Apple Computer, Inc.
d) Press down on the ink
d) Carefully remove and discard cartridge until you hear
the black plastic shield and the it click into position.
orange protective cap.
IMPORTANT: Do not touch
the copper-colored contacts.
e) Open and uncap the color
ink cartridge. Insert it into
e) Place the printhead into the printhead.
the carriage. Insert at the
angle shown.
f) Press down firmly on the
ink cartridge until you
hear it click into position.
It is normal for the printhead
to flex when inserting the
f) Push firmly against the back
cartridge. You will not damage
wall of the printhead until
the printer.
it clicks into place.
g) Close the printer access door.
Tip: The printhead requires a
firm push and makes an audible
click when locked into place.
6
Connect Power
5
Install Ink Cartridges
a) Connect the power supply
and adapter.
a) Remove the black ink
cartridge from it's bag.
IMPORTANT: Insert ink
cartridges immediately
upon opening sealed bag.
b) Carefully remove and b) Remove the plastic film from the
discard the orange cap. LCD display. Position the LCD
Handle ink cartridges display.
carefully to avoid ink
transfer.
c) Press ON. When prompted, use
the key to select a language.
c) Insert the black ink
cartridge into the
Use the key to select a region.
printhead.
Control Panel Features
On/Off Copy Magnify
Phonebook
Fax
Rotate
1
On/Off 2
Phonebook 3 EasyShare 5500
abc
def
Copy Rotate
4
5
6
ghi
jkl
mno
7
8 Menu
Fax Photo
9
pqrs
tuv Zoom
wxyz
*
0
#
All-in-One Printer
Symbols
Scan
Transfer
Space
Scan Transfer
Menu Photo
Helpful Tips
2. Select Print Calibration Page and press OK.
3. When the print comes out, place it at the back, left corner of the scanner
Pull out the output tray extender
glass.
to help collect your 8.5"x11"
prints.
4. Close the scanner lid and Press START.
PROBLEM:
My calibration page printed on plain white text paper.
SOLUTION:
Follow the directions as listed in step 8. Calibration will work successfully on
The photo tray light illuminates
both plain white paper and photo paper.
when the photo tray is pushed in.
To use the main paper tray,
PROBLEM:
disengage the photo tray by
I cannot print to my desired paper type.
pulling it towards you.
SOLUTION:
Check to see if the photo tray is pushed in. You can do this by checking if the
green photo tray light is illuminated. If it is, all prints will be produced from
this tray. If you want to print from the main tray, disengage the photo
tray by lifting the photo tray lid and sliding the paper tray toward you (See
step 8d).
Getting Started
PROBLEM:
You can access and use the AiO Home Center by double-clicking on the
I have a paper jam.
icon on your desktop.
SOLUTION:
1. Press in the tabs on the rear access door to remove the door.
Windows
2. Gently pull the paper out of the rollers.
The AiO Home Center will enable you to copy, scan, and IMPORTANT: If the paper tears while removing it, check inside the
configure your AiO Printer from the computer. You can also printer for torn pieces of paper and remove them. Additional jams are
launch Kodak EasyShare software for transferring, viewing,
likely to occur if all of the torn pieces are not removed.
and working with your digital pictures and videos.
3. Replace the rear access door. Gently push the door forward until it snaps
into place.
Macintosh
Is Further Troubleshooting Required?
The AiO Home Center will enable you to configure your AiO
Printer from the computer. You can also order supplies and
launch Kodak EasyShare software for transferring, viewing, If you need further information to help answer your questions, please contact
and working with your digital pictures and videos. Use the Technical Support and have your KSN number ready. Your KSN number can
Kodak EasyShare AiO drivers to print and scan to your AiO
be found on the unit after lifting the printer access door as shown.
Printer.
Troubleshooting
If you have additional questions about troubleshooting this device, please
visit www.kodak.com/go/5500aiosupport
PROBLEM:
I cannot get a calibration sheet to print.
SOLUTION:
When necessary, you can force a calibration sheet to print by following these
steps:
1. Press Menu, select Calibrate Printer and press OK.
7
Connect Fax Line
Use the instructions in this section to connect the fax feature of your printer.
More setup configurations can be found in the User's Guide.
SEPARATE FAX LINE:
Connect your printer to the phone line as shown in the illustration if you have
a separate fax line on which you receive no voice calls, and you have no other
equipment connected on this phone line.
a) Connect a phone cord to your telephone wall jack and the port
labeled 1-LINE.
b) Set your Ring to Answer setting by following the steps below.
1) Press Menu and select Fax Settings.
2) Press the to scroll down to Rings to Answer.
3) Use the or keys to select a number.
When the phone rings, your printer will answer automatically after the number
of rings you set in the Ring to Answer setting. It will then send fax reception
tones to the sending fax machine and receive the fax.
SHARED VOICE/FAX LINE:
Connect your printer to the phone line as shown in the illustration if you
receive both voice and fax calls at the same phone number, and you have no
other equipment connected to this phone line.
4952368
a) Connect a phone cord to your telephone wall jack and the port
labeled 1-LINE.
b) Connect your phone to the port labeled 2-EXT on the back.
c) Turn on Answering Machine Mode by following the steps below:
1) Press the Menu button.
2) Press the to highlight Fax Settings. Press OK.
3) Press to select Yes for Ans. Machine Mode.
-ON
More accessories
More options
More convenience
Cancel
The KODAK EasyShare All-in-One Printer gives you more. Be sure to visit
our online store to select from our full line of supplies and accessories at
Cancel
Attention
www.kodak.com/go/AiO
Start
OK
Start
Kodak's Inkjet Photo Paper
OK
Get prints that look great the first
time with Kodak's unique backprint
technology that automatically
enables optimized prints.
Value Packs
Save up to 50% on everything you
print and pay as low as 10 cents a
print with our ink and paper Value
Packs
.
Wireless Adapter
Go wireless with the Kodak Wireless
2.0 USB Bluetooth Adapter.
Wireless
Bluetooth Adapter 2.0 USB
Note: A USB 2.0 cable is required to connect your Kodak All-in-One printer
to your Windows or Macintosh OS computer. Available in the Kodak online
store or see your local retailer.
KODAK SERVICE NUMBER
F330065
*F330065*
*F330065*
Need More Help?
Look here for answers:
www.kodak.com/go/5500aiosupport
User Guide
The User Guide is installed with your Kodak AiO Software and is located:
Windows
Start All Programs Kodak
Macintosh
Library Documentation Kodak AiO Printers