Step 3 Inserting
a cassette
(1) Install the battery pack, or connect the AC power adaptor for the power supply
(p. 18 to 22).
(2) Slide OPEN/&EJECT
in the direction
of the arrow and open the cassette lid.
The cassette compartment
automatically
lifts up and opens.
(3) Push the middle portion of the back of the cassette to insert it. Insert the
fs
cassette in a straight line deeply into the cassette compartment
with the
2
3
window
facing out.
0
(4) Close the cassette compartment
by pushing down the cassette lid halfway.
The
x
'Y
cassette compartment
automatically
goes down.
(5) After the cassette compartment
goes down completely,
close the lid until it
clicks.
i+
P
2
OPEN/=EJECT
b To eject the cassette
Follow the procedure above, and take out the cassette in step 3
Notes
l
Do not press the cassette compartment
down firmly. Doing so may cause a
malfunction.
l
Before you open the cassette lid, be sure to disconnect the A/V connecting cable,
i.LINK cable, and USB cable (DCR-IP7BT only). If you open the cassette lid without
disconnecting the cables, the cables or plugs of the cables may be damaged.
To prevent accidental erasure
Slide the write-protect
tab on the cassette to expose the red mark.
27