Sony DCR-IP5 Operating Instructions Manual page 197

On trademarks
l
ImageStation is the registered trademark of Sony Corporation.
l
"Memory Stick" and *ecV are registered trademarks of Sony Corporation.
l
The BLUETOOTH trademarks are owned by their proprietor and used by Sony
Corporation under license.
*NetFront by Access Co., Ltd. is adopted for the Internet function of this product.
NetFront is a registered trademark of Access Co., Ltd in Japan.
Copyright 0 1996 - 2001 ACCESS CO., LTD.
l
Portions of the supplied software are based in part on the work of the Independent
JPEG Group.
All other product names mentioned herein may be the trademarks or registered
trademarks of their respective companies. Furthermore, "1'1" and "0" are not
mentioned in each case in this manual.
No compensation for your recordings
Contents of the recording cannot be compensated for if recording or playback of
attached or downloaded files is not made due to a malfunction, problems with storage
media, etc.
Precautions
*Before using the network function, be sure to set up the clock of the camcorder. For
details, refer to the operating instructions of the camcorder. If you use the network
function without setting the clock, you may not be able to send or receive e-mail, or
view a Web page.
l
Do not remove the battery pack or disconnect the AC power adaptor while in
NETWORK mode. The setup for the NETWORK mode may be lost. Also, exit the
NETWORK mode when setting the POWER switch to OFF (CHG) or switching the
mode.
l
We recommend that you make backup copies of your e-mail messages and your
network preferences. These may be lost from time to time due to memory corruption.
To save the network preferences, write them down on paper, or use "Setup memo,"
described on page 120. Also, this data may be lost when the camcorder is repaired by
repair services.
*The network function is available only in the U.S.A.
l
The reset button cannot reset the network preferences.
Note on network operation when using the battery pack
When the remaining battery time is insufficient in NETWORK mode, use the AC power
adaptor or replace the battery pack with a fully charged battery pack. Before connecting
the AC power adaptor or replacing the battery pack, be sure to exit the NETWORK
mode.
2