Sony DCR-IP5 Operating Instructions Manual page 182

Maintenance information and precautions
Charging the built-in rechargeable battery:
l
Connect your camcorder to the house current using the AC adaptor supplied with
your camcorder, and leave your camcorder with the POWER switch turned off for
more than 24 hours.
l
Install a fully charged battery pack in your camcorder, and leave your camcorder with
the POWER switch turned off for more than 24 hours.
Camcorder operation
l
Operate your camcorder on 7.2 V (battery pack) or 8.4 V (AC power adaptor).
l
For DC or AC operation, use the accessories recommended in this operating
instructions.
l
If any solid object or liquid gets inside the casing, unplug your camcorder and have it
checked by a Sony dealer before operating it any further.
l
Avoid rough handling or mechanical shock. Be particularly careful of the lens.
l
Keep the POWER switch set to OFF (CHG) when you are not using your camcorder.
l
Do not wrap your camcorder with a towel, for example, and operate it. Doing so
might cause heat to build up inside.
l
Keep your camcorder away from strong magnetic fields or mechanical vibration.
*Do not touch the LCD screen with a sharp-pointed object.
l
Do not strongly press the LCD screen.
l
If your camcorder is used in a cold place, a residual image may appear on the LCD
screen. This is not a malfunction.
l
While using your camcorder, the back of the LCD screen may heat up. This i?not a
malfunction.
*Do not use the network function in a medical institution or in an aircraft (DCR-IP7BT
only).
:
On handling tapes
l
Do not insert anything into the small holes on the rear of the cassette. These holes are
used to sense the type and thickness of the tape and if the recording tab is in or out.
l
Do not open the tape protect cover or touch the tape.
l
Avoid touching or damaging the terminals. To remove dust, clean the terminals with
a soft cloth.
Camcorder care
l
Remove the tape, and periodically turn on the power, operate the CAMERA and VCR
sections and play back a tape for about 3 minutes when your camcorder is not to be
used for a long time.
l
Clean the lens with a soft brush to remove dust. If there are fingerprints on the lens,
remove them with a soft cloth.
l
Clean the camcorder body with a dry soft cloth, or a soft cloth lightly moistened with
a mild detergent solution. Do not use any type of solvent which may damage the
finish.
l
Do not let sand get into your camcorder. When you use your camcorder on a sandy
beach or in a dusty place, protect it from the sand or dust. Sand or dust may cause
your camcorder to malfunction, and sometimes this malfunction cannot be repaired.
182