ACME LED-7TC User Manual page 7

Led panel

Hide thumbs Also See for LED-7TC:

Table of Contents

Led Display

Press the MENU button up to when the

button and the display will blink. Use DOWN and UP button to select the

(Led off) mode. Once the mode has been selected, press the ENTER button to

setup or automatically return to the main functions without any change after 8 seconds. To

go back to the functions without any change press the MENU button again.

Display Inversion

It is good for you to install the unit on the floor or under ceiling. Press the MENU button up to

when the

is shown on the display. Pressing ENTER button and the display will blink.

Use DOWN and UP button to select the

normal). Once select, press the ENTER button to setup or automatically return to the main

functions without any change after 8 seconds. To go back to the functions without any

change press the MENU button again.

Fixture Temperature

Press the MENU button up to when the

button and the display will show the temperature of the unit. To go back to the functions press

the MENU button again.

White balance

Press the MENU button up to when the

button and the display will blink. Use DOWN and UP button to select the

(green) or

(blue), press ENTER button to confirm, then use DOWN and

UP button to adjust the value (125-255) and press ENTER button to store, automatically

return to the main functions without any change after 8 seconds. To go back to the functions

without any change press the MENU button again.

Fixture Hours

Press the MENU button up to when the

button and the display will show the number of working hours of the unit. To go back to the

functions press the MENU button again.

is shown on the display. Pressing ENTER

(Led on)

(display inversion) or

is blinking on the display. Pressing ENTER

is shown on the display. Pressing ENTER

is blinking on the display. Pressing ENTER

(display

(red) or

Table of Contents