User Configurable Options - TurboChef NGC (Tornado) Service Manual

Hide thumbs

Table Of Contents

Table of Contents

EDIT GROUPS

GROUP A

GROUP E

GROUP B

GROUP F

GROUP C

GROUP G

GROUP D

GROUP H

       : Edit Groups

3. Select the Recipe Group which contains the

individual Recipe you wish to alter. Select which

Recipe you wish to alter by pressing the Soft Key

corresponding to the Recipe Item. Figure 8.

4. Use the "Up and Down Arrows" Keys to

navigate through a Recipe. Use the Keypad and

"Enter" Key to alter any of the following three

(3) parameters: (See Figure 9.)

1. Cook Time

Total duration of the Cook Cycle. Enter the

desired time and press "Enter". Valid times are

between one (1) second and five (5) minutes.

2. Infrared Set Point Temperature (IR SETPT)

The relative temperature which the lower

radiant element will maintain during the

entire Cook Cycle. Valid temperatures are

between 500 º F and 1150 º F.

3. Events 1...6

Use the Keypad and "Enter" Key to enter values

for Percent (%) Time, % Air and % Microwave

(MW).

The % Time for all Events must total 100%.

The operating system will not allow a combi-

nation of Events not totaling 100% or that

exceed 100%.

GROUP A

ITEM 1

ITEM 5

ITEM 2

ITEM 6

ITEM 3

ITEM 7

ITEM 4

ITEM 8

       : Edit Groups

The % Air and % Microwave (MW) parameters

are valid between 10 and 100%.

   : If an Event is unused, the % Air param-

eter may default and be displayed as 10%.

Once the desired changes have been made, test

the Recipe by pressing the "Test" Soft Key. This

will execute the altered Recipe. Once satisfied with

the Recipe, press "Save" to permanently store any

changes. Press the "Back Arrow" Key four (4) times

to exit the Edit Mode.