Table of Contents
Advertisement
2
INSTALL ATION, SPECIFICATIONS AND MAINTENANCE
Power Supply - North America
Universal Voltage:
Amperage:
Cordset:
Plug:
: The Smart Voltage Sensor Technology does
not compensate for lack of or over voltage situations.
It is the responsibility of the owner to supply voltage
to the unit according to the above specifications.
DELIVERY AND PRODUCT PL ACEMENT
Remove oven from carton. Immediately note any
damage and contact shipping company within 24
hours in order to file a claim. TurboChef will not
be responsible for product damaged in shipment.
The carton may be discarded after oven is removed.
: Oven weight is approx. 190 lbs.
Two or more persons are required to lift it.
Lifting and Placement of the Oven
Position one or more persons on either side of the
oven and lift from the bottom. Never lift the oven
from the front and rear. Place the oven on a coun-
tertop surface at least 28 inches deep and capable
of supporting 200 lbs.
Once properly positioned on the counter, plug the
oven into a NEMA 6-30R wall mounted electrical
receptacle. See Electrical Specifications.
Restraint Oven Kit (P/N TC3-0240)
An optional system intended to hinder the oven
from moving forward during use and/or cleaning.
The Restraint Oven Kit will not prevent the oven
from falling off a countertop if the legs are allowed
to slide off the edge or if the oven is intentionally
or forcefully pulled off.
208/240 VAC , 60 Hz,
1 phase
Nameplate rating 30 Amp
(3-wire including ground)
10 gauge, 3 conductor,
5 foot cordset
NEMA 6-30
Proper installation instructions are included in the
Restraint Oven Kit, if the operator has ordered one.
If additional help is needed, please call customer
service at 800.90TURBO .
ELECTRICAL SPECIFICATIONS
Operating Voltage
Current Draw
Phase
Frequency
Max Input
Microwave Input Power
*Maximum Independent Input Power
: Never lift the oven by its door
handle. Physical damage to the oven and/or
personal injury may result. The operator must ensure
that the oven is properly placed on the countertop
at all times. TurboChef will not recognize a fallen
oven as a warrantable claim and is not liable for any
injuries that may result.
SETUP AND INITIAL OPERATION
Setup
Once oven is properly positioned on the counter,
remove any packing material and/or any foreign
objects from within the cavity. Install the oven rack
by sliding the rack onto the support shelves.
Programming
The oven comes preprogrammed and is ready to
operate out-of-the-box.
Initial Power-up
To turn the oven On, press the "On" Key next to
the word "On" on the display. The oven will begin
to warm up to its predefined cooking temperature
of 500 º F. This takes approximately 10 minutes.
When the Warm-up Cycle is completed, the oven
will beep and display the "Ready State". At this
point, the oven is ready to cook.
208 VAC/240VAC
30 Amps
1 Phase
60 Hz
5990/6675 watts
3500 watts*
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
