Brake Release Switch - Permobil C350 Service Manual

Brake release
Brake release
Removing the brake release switch
1. Raise the seat; electric seat lift to the highest
position; fixed seat tube to the service position.
See page 28. If the electric seat lift does not
work normally because the batteries are dis-
charged or the adjustment device is defective,
the seat can be raised/lowered manually. See
page 26.
2. Switch off the main power switch on the con-
trol panel.
3. Remove the upper and front chassis cover.
See page 8.
4. Release the brakes by pressing the release
control forwards and at the same time pulling
it straight out (see illustration).
5. Divide the brake release switch cabling at the
contact on the cabling. This is positioned on
the top of the rear battery.
6. Remove the brake release switch. It is held in
place with two screws.
Fitting the brake release switch
Fit in the reverse order.
NB
Check the function of the break release after fitting. When the
brakes are released, it should not be possible to drive the
wheelchair.
Release the brakes by pressing the release
control forwards and at the same time pulling
it straight out.
The brake release switch is fitted with two screws
on the left drive motor magnetic brake.
24