Functioning - Cino eC Pro Installation And Maintenance Manual

cino eC PRO by
09.01.l. clock
09.01.m. out of service
09.01.n. product qty
09.01.o. maintenance
09.01.p. RFID CARD
09.01.q. tuning motors
09.01.r. calibration
product flux
09.01.s. product audit
flux
09.01.t. id. machine
09.01.u. variflex brewer
09.01.a. button from 1
to 10

"functioning"

MAN1010119 rel. 01 dated 30.01.2014
www.rheavendors.com
to set up the machine clock;
to record any failure that may have occurred;
to check and enable product dispensing cycles;
it contains the maintenance control parameters of the machine;
to determine the RFID card parameters;
to regulate the time of product motors and the grinder motor;
programming of the product quantities delivered per unit of time;
products delivery data;
it contains the machine identification parameters;
coffee brewer programming;
press key "2" when the display shows "key n" to scroll the variables
composing the function of that key (by pressing keys "4" and "5");
- if you press "2" when "FUNCTIONING", the key will perform the
function you have programmed (dispensing cycle of a drink);
see paragraph "functioning";
- if you press "2" when "INHIBITED", the key will be inhibited and
it will perform no function;
- if you press "2" when "PRESELECTION", the key you have pressed
before the real selection will fulfil the function of the items listed
in the "preselection" paragraph (scroll by pressing key "4" and
"5");
use key "2" to scroll the following items:
choose the "extended" option to display all variables and the
"reduced" option to display only the parameters, the values of
which are other than zero (use keys "4" and "5" to change the
option);
espresso coffee is the first product you can programme for each
selection key; there are two variables:
- the water quantity in the cup; change it by means of "4" and
"5"; if the variable is zero, no espresso will be dispensed (drink
composed by instant products only);
- coffee will be dispensed before (value 1) or after (value 0) instant
products;
- to allow the adjustment of the internal coffee group pressure
increasing the height of the chamber (from 0 to 10 mm);
press "2" to display:
press keys "4" and "5" to change the rotation time of the N product
motor, thus changing the product quantity you have dispensed; if
time is zero, no product N will be dispensed; you can carry out a
"time test" on the set-point; (see 13.18.);
tel: 0039 02 966 551
rheavendors group's sole property
fax: 0039 02 96 55 086 e mail: rheavendors@rheavendors.com
PROGRAMMING
CLOCK
REGISTRATION
OUT OF SERVICE
PROGRAMMING
PRODUCT QTY
PROGRAMMING
MAINTENANCE
PROGRAMMING
RFID CARD
TUNING
MOTORS
CALIBRATION
PRODUCT FLUX
PRODUCT AUDIT
FLUX
PROGRAMMING
ID MACHINE
PROGRAMMING
VARIFLEX BREWER
FUNCTIONING
INHIBITED
PRESELECTION
programming:
TOTAL
programming:
PARTIAL
COFFEE WATER EXP.
0= inhib. cc: 00
coffee sequence
1=coffee before N
Brewer pressure
0=max 10=min. 00
PRODUCT N
0= inhib. 0.0
page no. 27 of 52 page