Cino eC Pro Installation And Maintenance Manual page 17

cino eC PRO by
05.25. product motors
05.26. mixing bowls
05.27. nozzle support
05.28. mixer motors
05.29. powder aspirator
05.30. air aspirator
05.31. air break
05.32. volumetric counter
05.33. coin box
05.34. door lighting
MAN1010119 rel. 01 dated 30.01.2014
www.rheavendors.com
they are intended to rotate the worm screws inside instant product
canisters to pour the product quantity necessary for selection in the
mixing bowls;
the mixing bowls of the mixer will accommodate the instant
products you have poured to mix them with water; the fan of mixer
motor will act at the bottom and the drink outflow to the dispenser
occurs by means of a silicone tube; mixing bowls and outlet tubes
can be washed with lukewarm running water;
a fixed support on the cup station is intended to house the
dispensers from the coffee brewer, the mixer bowl and the direct
hot water unit;
press the release lever to move it to the right to clean or to remove
the coffee brewer;
the motors of mixers help you mix instant products with water by
means of the rotation of the fan mounted on their axis; the
rotation speed can be adjusted (see 09.01.a.) to the features of the
various products;
an aspirator will eject suspended product residuals from the
vending machine; the aspirator is connected with a drawer beneath
product slides to intercept the residual impalpable powder coming
from selections; the action time of the aspirator is programmable
by means of a software parameter (see 09.01.f.); aspirated air is
ejected through the slots of the rear panel;
to aspirate the air from the internal environment of the machine to
avoid any condensate;
it accumulates water for sending to the pressure boiler; the level is
controlled by a float and – if above the established level – it will
flow back to the inlet solenoid valve safety device, thus preventing
the inlet of new water;
it supplies the CPU the water quantity running through the coffee
brewer to establish its volume; the water quantity of instant
selections is established by the time set in the "water N" parameter
only (see 09.01.a.);
the components intended to support the payment system (not
supplied) are made available in some versions, inside the door; the
coin box is equipped with a lock and the payment system cable
shall be connected with the CPU board; (see 05.37.a.);
- each selection key is lighted by a led mounted on the display
board (see 05.37.b.);
- the front transparent stud, the dispensing compartment and the
door panel are lighted by a led mounted on printed circuits inside
the door;
the dispensing compartment is lighted by four leds in standby
mode and during a dispensing cycle;
leds of different colours turn on alternatively to signal the end of
a dispensing cycle;
tel: 0039 02 966 551
rheavendors group's sole property
fax: 0039 02 96 55 086 e mail: rheavendors@rheavendors.com
25
26
27
28
31
29
30
32
33
34
page no. 17 of 52 page