Cino eC Pro Installation And Maintenance Manual page 16

cino eC PRO by
05.14. internal button
(PROG)
05.15. flash key housing
05.16. label slot
05.17. coffee brewer
05.18. brewer presence
switch
05.19. coffee brewer
heater
05.20. coffee brewer
motor
05.21. grinder
05.22. grounds container
05.23. product canisters
05.24. water door
MAN1010119 rel. 01 dated 30.01.2014
www.rheavendors.com
the button giving access to the machine programming mode is
arranged on the orange protection carter inside the door;
programming flash keys are arranged in the carter inside the door
(see 09.06.);
product labels are arranged inside the door panel, beneath the
orange carter;
insert the labels into the pockets by observing the machine
configuration (see 13.02.);
after receiving the coffee dose from the grinder and compressing it,
percolation occurs in the coffee brewer with the water from the
pump; the used dose is conveyed towards the slide and the drawer
at the bottom of the machine; the structure of the brewer is kept at
the correct temperature by a hot air heating system programmable
via software (see 09.01.e.);
the coffee brewer presence is controlled by a micro-switch that can
inhibit the selections including coffee beans, if it is not present;
a safety cover is intended not only to protect the operator against
moving parts, but also to keep the coffee brewer at the correct
temperature through an air heater preserving the drink quality
even after a long vending machine pause;
the variable coffee brewer motor is intended to regulate the
chamber closing and compressing phases in order to compress
ground coffee for its percolation; its action is controlled by an
encoder that informs the CPU on the brewer position;
it grinds the coffee beans in the canister to pour it in the coffee
brewer chamber; the grinding degree can be manually adjusted by
means of the wheel you can access after removing the coffee
canister whereas the ground quantity is determined by a software
parameter (see 09.01.a "grinder time") that establishes the grinder
work time;
it collects over thirty ground doses after having used them in the
coffee brewer; a software option (see 09.01.o.) will show a warning
message as soon as the tray is full;
instant product canisters dispense their content in the underlying
mixing bowls; an internal worm screw driven by the product motor
will push the instant product to the product slide; they can be
equipped with a wheel and a product shaker for constant
dispensing; the outlet, the dimension of which can be either
standard or smaller, has got a closing baffle;
the coffee beans canister (hopper) has a closing blade; pull it
before lifting the container; the presence of the coffee beans
canister is detected by a switch;
to protect the products, containers are closed by a cover; a water
tank is intended for supply in the versions not connected with the
water network (see 01.01.); this tank can be filled through a hatch
of the vending machine cover;
in A machines, a door on the vending machine cover will enable
you to access to the internal water tank and fill it in;
an internal water tank is complete with a float signalling by means
of a red strip if you have filled it in excess;
tel: 0039 02 966 551
rheavendors group's sole property
fax: 0039 02 96 55 086 e mail: rheavendors@rheavendors.com
14
15
16
17
18
19
20
21
22
23
24
page no. 16 of 52 page