3Com ACCESSBUILDER 4000 Installation Manual page 53

Risc-based multiprotocol, multiport networking devices

Hide thumbs Also See for ACCESSBUILDER 4000:

Table of Contents

Error Messages

4-5

These messages are displayed only on the local AccessBuilder management

console, or the SNMP management station. They are not available to the

Transcend AccessBuilder Management station.

You can set the level of messages you want displayed, according to the

following categories:

Status level includes messages displayed by the system about the status of

hardware and software. These messages are usually for information only and

do not impact your ability to continue working.

Warning level (default) displays only messages that indicate potential

problems detected by the software. The system may continue to function,

but it is recommended that you take the action speciﬁed in the following

section to correct the problem.

Error level displays messages that indicate a conﬁguration error condition.

The system may not function unless the error is corrected by reconﬁguring

and rebooting the system.

Panic level displays messages that indicate a severe problem has been

detected. The system is halted, and enters monitor mode. You must take the

speciﬁed action, and reboot the system, to bring the system up again.

All messages are displayed with a time stamp and the text of the message.

A detailed list of these error messages along with a brief description and

suggestions for any action you should take may be found in the optional

AccessBuilder Administrators Guide. Messages in each category are listed in

alphabetical order.

Table of Contents

Need help?

Do you have a question about the ACCESSBUILDER 4000 and is the answer not in the manual?

Accessbuilder 4000 series