Table of Contents
Advertisement
G
S
ETTING
TARTED
2
This section is designed to help you to quickly perform the installation of an
AccessBuilder 4000 network remote access server. Once you have planned
your installation and set up the hardware, you are then ready to install and
launch the Transcend™ AccessBuilder Manager (TABM) configuration
utility. From there, you'll configure your AccessBuilder using TABM's on-line
help information as required to perform specific configuration items.
Before the Transcend ™ AccessBuilder Manager configuration utility can be
used, the following condition must be true:
IP Networks: Your third-party TCP/IP stack must be installed and you can ping a
known host on the network.
IPX Networks: Your NetWare Windows client software must be installed and
you can attach to a NetWare server. A NetWare server must also reside on the
network to which the AccessBuilder is attached.
AccessBuilder
Nearly all AccessBuilder configuration can be performed using the
Configuration:
Transcend™ AccessBuilder Manager (TABM) configuration utility in a
Windows or
Windows environment. There are, however, situations where it is necessary
Command Line UI
to use the AccessBuilder's command line interface to perform specialized
configurations. These situations include:
When a Windows platform with a third-party TCP/IP stack (IP networks) or
NetWare Client is not available on the network to which the AccessBuilder is
attached
When it is more convenient to use a local console on the AccessBuilder's
asynchronous port
When using telnet (IP networks) to configure the AccessBuilder
When configuring bridging filters (refer to the Release Notes for any other
special circumstances)
Advertisement
Table of Contents
Need help?
Do you have a question about the ACCESSBUILDER 4000 and is the answer not in the manual?
Questions and answers