Hardware Installation; Stand Alone - 3Com ACCESSBUILDER 4000 Installation Manual

2-6 C 2: G
HAPTER ETTING
Hardware
Installation

Stand Alone

S
TARTED
If the original carton was damaged in shipment, repack the system in a
carton that provides equivalent protection before returning it to 3Com.
3 Verify that you have received all items included with the unit.
Hardware
Software
Documentation
If you have not received all items on the packing list, first check the Release
Notes for any late changes, then contact your AccessBuilder supplier for
assistance.
4 Verify that the AccessBuilder 4000 system's power specifications listed in
Appendix A corresponds to your facility's available power source.
If the available power source does not correspond to the acceptable range,
contact your AccessBuilder supplier for assistance.
5 Write down the serial number of the chassis and the MAC address.
The serial number and MAC address are listed on labels on the bottom of
the unit. The label contains the UL listing, FCC numbers, and the serial
number with a bar code.
Before powering on the system, make sure that the cover is properly
WARNING:
secured in place. Powering on the system without the cover in place can result in
overheating the system and the potential for electric shock.
The following is a step-by-step procedure for performing the AccessBuilder

4000 hardware installation.

Pick a suitable location for the AccessBuilder 4000. Either a desktop or
similar level surface may be used. You may also want to locate the modems
AccessBuilder 4000 Chassis
Rack Adapter Kit
Power Cable
BNC Connector
1 CD-ROM
Information Roadmap
AccessBuilder 4000 Installation Guide
Remote Client Installation Guide
AccessBuilder Server Release Notes
Remote Client Release Notes